Do not use Sensifirm if you:
Are pregnant or breastfeeding · Have an active electrical implant (like a pacemaker or defibrillator) · Have metal implants in the treatment area (excluding dental) · Have active skin infections, herpes, eczema, or psoriasis in the treatment area · Have tattoos in the treatment area · Are under 18 · Never use on the face, neck, chest, or breasts.
If you have recently had surgical or aesthetic treatments, have uncontrolled diabetes, or have a history of keloid scarring, consult your physician first. See the full User Manual for the complete list.
Required: Patch Test
Do this once before your first full treatment.
Apply Base Gel to a small test patch. Use the device for 5 minutes at the lowest energy level. Wait 24 hours. If your skin looks normal (no blistering, burns, or prolonged redness), you are ready for a full session. You can gradually increase the energy level in future sessions if comfortable.
Preparation Checklist
Do this before every session.
Clean skin
Ensure the treatment area is completely clean and dry. Do not apply any lotions, oils, or powders beforehand.
Remove jewelry
Take off any jewelry, watches, or metal accessories in or near the treatment area.
Apply Base Gel
Apply an even layer of Sensica Base Gel to the area. This is mandatory for the RF energy to penetrate properly and safely.
Connect
Plug in your Sensifirm device and press the power button to turn it on.
Remember: Do not use Sensifirm over broken skin, tattoos, or active skin conditions. The device requires continuous movement during treatment to avoid overheating.
Simple steps. Real results.
A straightforward routine that helps you achieve smoother, firmer skin.
Ensure your skin is clean and dry. Do not apply any lotions or oils beforehand.
Apply a thin, even layer of Sensica Base Gel to the treatment area.
Plug in the device and select your energy level (1-3). Start at level 1.
Move the device continuously in slow, circular motions over the treatment area.
Wipe off any remaining gel and apply your favorite body moisturizer.
If you do not feel warmth after about 30 seconds, make sure all electrodes have full skin contact. Increase the level if needed.
Where to use Sensifirm
Designed for body contouring on larger areas.
Outer Thighs
The most co separately.
Buttocks
Divide into upper and lower halves. Treat each side separately.
Abdomen
Treat the lower and upper abdomen areas separately.
Arms
Treat each arm separately, focusing on the upper arm area.
After Each Session
Post-treatment care
✔ DO
- Wipe off any remaining Base Gel from your skin and the device
- Apply your favorite standard body moisturizer to the treated areas
- Drink plenty of water to help your lymphatic system flush out broken-down fat
✖ DO NOT
- Do not wash the device with water (use a dry or slightly damp cloth)
- Do not apply harsh chemical exfoliants or scrubs immediately after
- Do not use the device on the same area more than once a week
Mild redness or a warm sensation after a session is normal and means the RF energy is working. It typically resolves within hours.
What your 8 weeks look like
A treatment once a week for the first 8 weeks, then maintenance as needed.
Meet your skin expert. They are here to help you every step of the way.
Order arrives
Sessions 1-2
Begin weekly treatments. RF energy starts shrinking fat cells.
Sessions 3-4
Initial visible improvements in skin firmness are often seen.
Discuss your progress.
Sessions 5-6
Lymphatic drainage continues to flush out broken-down fat.
Sessions 7-8
Fuller results for cellulite reduction. Tighter, contoured skin.
Beyond week 8: you can repeat the 8-week protocol as needed to maintain optimal results.